The DS/DSA are quad line receivers Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet. The DS/DSA are quad line receivers designed to .. Reproduction of TI information in TI data books or data sheets is permissible. D Input Resistance 3 kΩ to 7 kΩ. D Input Signal Range ±30 V. D Operate From Single 5-V Supply. D Built-In Input Hysteresis (Double. Thresholds).
|Published (Last):||20 September 2015|
|PDF File Size:||12.56 Mb|
|ePub File Size:||17.10 Mb|
|Price:||Free* [*Free Regsitration Required]|
All inputs are protected against damage due to electrostatic discharge by diodes to VCC and ground. Share to Twitter Share to Facebook. Posted by Datasheet at Monday, March 17, tl TI datasheet download pdf.
DS Datasheet PDF – National ->Texas Instruments
Further, a single capacitor can be added to reduce the 0. This considerably simplifies its application since no external components are necessary for operation.
Two totem-pole outputs provide dattasheet rise- and fall-time performance for power FET control. Features n TTL input compatible n Typical propagation delays: Designed primarily for power-supply control, the TL provides the de1489 engineer with the flexibility to tailor the power-supply control circuits to a specific application.
Posted by Datasheet at 5: The LM series has internal unity gain frequency compensation. However, unlike most internally compensated amplifiers, external frequency compensation may be added for optimum performance.
DNational Semiconductor. This enables the construction of serial and terminal interfaces while maintaining minimal power consumption. In addition, the voltage reference input can be adjusted to allow encoding any smaller analog voltage span to the full 8 bits of resolution. This device has enable and datasbeet circuitry common to all four drivers. Overcompensation can be used with the amplifier for greater stability when maximum bandwidth is dahasheet needed. LNational Semiconductor.
DS (National Semiconductor) – Quad Line Receiver, Transeivers
ANational Semiconductor. The TL contains two error amplifiers, an internal oscillator externally adjustablea dead-time control DTC comparator, a pulse-steering flip-flop, a 5-V precision reference, undervoltage lockout control, and output control circuits.
SPiKe protection means that these parts are safeguarded at the output against overvoltage, undervoltage, overloads, including thermal runaway and instantaneous temperature peaks. The outputs share a common source supply and common power ground terminals, which allow system designers to eliminate errors caused by high current-induced voltage drops and common-mode noise. They feature a factor of ten increase in speed over general purpose devices without sacrificing DC performance.
They are constructed on a single monolithic silicon chip. Differential analog voltage inputs allow increasing the common-mode rejection and offsetting the analog zero input daasheet value.
This part uses special output circuitry that enables the drivers to power down without loading down the bus.