DAC is a D/A converter IC and is used for converting 8 bit digital data input to analog signal output. It is a monolithic IC featuring a full. The DAC is an 8-bit monolithic digital-to-analog con- verter (DAC) DAC is independent of bit codes, and exhibits essen- DAC data sheet. DAC data sheet. Features. Y Relative accuracy g0 19% error maximum ( DAC). Y Full scale current match g1 LSB typ. Y 7 and 6-bit accuracy available.
|Published (Last):||28 November 2016|
|PDF File Size:||11.48 Mb|
|ePub File Size:||14.7 Mb|
|Price:||Free* [*Free Regsitration Required]|
This op-amp circuit is called current-to-voltage converter. And the analog vatasheet from DAC is a current quantity and this needed to be converted in to voltage parameter for using in application easily.
DAC Pin Diagram, Features, Working & Datasheet
How to use DAC IC A typical application circuit for DAC is already given in the datasheet and we can use that circuit to develop applications without worry as the circuit is tested working. So this device is mainly used for reference and beginner applications and nothing more.
The device takes in parallel 8 bit data from a datxsheet or microprocessor and converts that data in to analog signal at the output.
DAC IC is used in applications where a digital to analog conversion is required. Similarly datasheeet can also use other application circuits for DAC given in the datasheet.
The chip accuracy of conversion is good and power consumption is also low to make it popular. The chip used to be popular a decade da and its applications used to be many but at present there are many modern IC which can perform DAC with higher resolution, speed and efficiency.
A typical application circuit for DAC is already given in the datasheet and we can use that circuit to develop applications without worry as the circuit is tested working.
088 to convert the current parameter in to voltage parameter we will use op-amp circuit as shown in circuit diagram. Working The device takes in parallel 8 bit data from a microcontroller or microprocessor and converts that data in to analog signal at the output.
DAC Technical Data
TL — Programmable Reference Voltage. This is a major drawback which is eliminated in modern DAC to make them work from a single power source. The output analog voltage from op-amp is in linear relation with input digital value and hence DAC conversion with DAC is achieved.
Submitted by admin on 27 October Pin configuration DAC is a sixteen pin device and description for each pin is given below.
The power supply currents of the DAC are independent of bit codes, and exhibits essentially constant device characteristics over the entire supply voltage range.